RS 21 - Page 74

72
100mm
TOP
SIDE
1950mm
1
TOP
STERN
STERN
BOW
BOW
2
Symmetric Spinnaker Pole Boom Storage
Fit the aft part rst by loosening the xing screw/plates.Slide the top xing into
the slot ontop of the inboard end of the boom. Slide the part down the boom until
the lower xing it against the mainsheet tting. Now rotate the xing plate on the
under side and slot it into the recess in the boom. As you tighten the xing it will
rotate to clamp the part in place. Then tighten the xing on the top of the boom.
Nest t the front tting, loosen the xing scres/plates enough to slide them into
the slot in the top side of the boom. Slide the tting along until it is 100mm from
the inboard end of the boom. Tighten the xings to hold the tting in place.