Audio Distribution System
AD-8x
32
WEB INTERFACE - ZONES PAGE
The Zones page of the web interface is used during AD-8x setup, allowing you
to adjust the source, power, mute, volume and the assigned group from a
device with a web browser such as a PC, tablet or smartphone.
View this page by clicking “Zones” tab at the bottom of the web interface.
ZONE CONFIGURATION
Click the “+” next to the zone you wish to congure and test.
• Sources: Select the audio input source for this zone.
• Power: Click on this button to power the zone on and off.
• Mute: Click on this button to mute the zone on and off.
• Volume: Current volume level is displayed on volume slider bar. To adjust
the volume level, use the raise and lower buttons or click on the volume
slider bar to jump to a level.
CAUTION: Clicking on the volume level bar will cause the volume
to JUMP to that level - be VERY careful where you click to prevent
accidently raising the volume to a high level.
• Group: Select the group that this zone will be a member of, or select “None”
if this zone isn’t going to be grouped with other zones. Grouped zones will be
controlled together, allowing volume levels to be adjusted simultaneously in
multiple zones.
NOTE: Zones can only be a member of one group.
CHAPTER 3 | INSTALLATION AND OPERATION
To Next Page
Loading...