19
It’s Under Control
®
KEYCAP
KEYCAP
REMOVAL
TOOL
KEYCAP
RETAINING
CLIP
Extra Keycaps included with T3-V+ kit
CHAPTER 2 | INTRODUCTION
KEYCAP REPLACEMENT
The T3-V+ kit includes a set of extra keycaps. They can be used instead of
the keycaps that are pre-installed on the ve customizable keypad buttons
located just below the touchscreen.
IMPORTANT NOTE: Do not attempt to replace any of the other button
keycaps on the remote, as they are not designed to be removed.
KEYCAP INSTALLATION
IMPORTANT NOTE: To avoid accidental scratching of the remote surface,
place a small piece of tape underneath the blade of the Keycap Removal
Tool adjacent to the keycap.
1) Using the Keycap Removel Tool (supplied), align the tip of the tool with
the inset groove located on the outside edge of the keycaps.
2) The keycaps are held in by a retaining clip. Gently pry up until the
keycap is loose and nish removal with your ngers.
3) Select the replacement keycap you wish to use and align it with the top
of the button on the remote, then press down till the retaining clips hold
the keycap in place.
KEYCAP
REMOVAL
TOOL
INSET
GROOVE
T3-V+
CUSTOMIZABLE
KEYPAD
BUTTONS (5)
To Next Page
Loading...
Need help?
General
