RTW PortaMonitor - Page 38

PortaMonitorPage 6-2  Getting started
6.3. Conneting 1063/10631-VID/1064/10641-VID
The PortaMonitor 1063, 10631-VID, 1064 and 10641-VID feature four
analog and two digital inputs, a power supply and a remote control
connector. The pinning is as follows:
Sub-D-25-pin.:
Pin: Function:
24 audio input analog 1 (+, hot)
12 audio input analog 1 (-, cold)
25 screen/case
10 audio input analog 2 (+, hot)
23 audio input analog 2 (-, cold)
11 screen/case
21 audio input analog 3 (+, hot)
9 audio input analog 3 (-, cold)
22 screen/case
7 audio input analog 4 (+, hot)
20 audio input analog 4 (-, cold)
8 screen/case
18 audio input digital (AES/EBU) 1 (+, hot)
6 audio input digital (AES/EBU) 1 (-, cold)
19 screen/case
4 audio input digital (AES/EBU) 2 (+, hot)
17 audio input digital (AES/EBU) 2 (-, cold)
5 screen/case
1 +24 V DC ±10 %, I
max
750 mA
14 +24 V DC ±10 %, I
max
750 mA
20 V
Power supply connector:
Remote control connector:
Pin: Function:
1 common potential for external switches
2 external function selection: gain
3 external function selection: memory reset
6 external function selection: loudness
7 external function selection: peak hold
8 external function selection: shift
9 external function selection: memory
10 external function selection: menu
11 external function selection: status
12 external function selection: opt 1
13 external function selection: opt 2
14 external function selection: RTA
15 external function selection: gonio
P i n 1
P i n 2
P i n 3
P i n 4
P i n 5
P i n 6
P i n 7
P i n 8
P i n 9
P i n 1 0
P i n 1 1
P i n 1 2
P i n 1 3
P i n 1 4
P i n 1 5
P i n 1 6
P i n 1 7
P i n 1 8
P i n 1 9
P i n 2 0
P i n 2 1
P i n 2 2
P i n 2 3
P i n 2 4
P i n 2 5
P i n 1
P i n 2
P i n 3
P i n 4
P i n 5
P i n 6
P i n 7
P i n 8
P i n 9
P i n 1 0
P i n 1 1
P i n 1 2
P i n 1 3
P i n 1 4
P i n 1 5
DC supply via multi-
core should be a
special exception.
The power supply and
the 25-pin sub-D
connector are wired
in parallel. The use of
a second supply or
shorting the corres-
ponding lines is
inadmissible.
The PortaMonitor requires
AES/EBU signal present at
digital input 1 for digital ope-
ration. The internal master-
clock will be devided from
this signal. Digital input
signals for input 2 must be
in sync to input 1.