On the main interface, you can press SET key shortly to enter into data setting interface. On the data setting
interface, press shortly V/↑or A/↓ to page up or page down to U-SET or I-SET, and then set the output voltage and
output current by same way used in the main interface .
Set the protection value.
Page up or page down to S-OVP, S-OCP or S-OPP place to set over-voltage value , over-current value and over-power
value correspondingly; when the value is up to the setting value, output will be closed. And then press shortly the
coding potentiometer to enter into the status of adjusting the numerical value you want to adjust. Turn coding
potentiometer to adjust the numerical value. If you want to exit adjusting the numerical value, press shortly SET key.
Adjust the brightness of screen.
Page up or page down to B-LED, and then press shortly the coding potentiometer to enter into the status of adjusting
the brightness of screen. Turn coding potentiometer to adjust the numerical value you need. If you want to exit
adjusting the numerical value, press shortly SET key. There are six brightness levels of LCD screen, 0-5 level. Rank 0 is
the darkest; rank 5 is the brightest. You can choose what you like.
Data setting and store the specified data group.
Page up or page down to M-PRE, and then press shortly the coding potentiometer to enter into the status of choosing
the data groups. Turn coding potentiometer to choose the data group you need to view. Then the data group you
need will be displayed. And then press the coding potentiometer to enter into status of changing output state.
Turn coding potentiometer to choose ON or OFF. When choose ON, the data group is extracted and the output status
remain the same. When choose OFF, the data group is extracted and the output is closed. If you want to exit choosing
data set, press shortly SET key. Then press shortly V/↑or A/↓ to page up or page down to other place to adjust the
data you need. After data setting done, keep pressing SET key more than 2s, all the data you set are automatically
stored into the specified data group. In the same time, you can see the group number on the right of screen. At last
you can press shortly SET key back to the main interface.
Set default boot open or close output
Page up or page down to S-INI, and then press shortly the coding potentiometer to enter into the setting status. Set
ON, default boot open; set off, default boot close.
Function description.
Open or close the output.
You can press ON/OFF key to open or close the output on any interface.
Lock the button to avoid wrong operation.
On the any interface, you can keep pressing coding potentiometer more than 2s, all buttons are locked. You can see
the key lock icon on the right of screen. If you want to unlock all buttons, keep pressing coding potentiometer more
than 2s, all buttons are unlocked. The key unlock icon will be displayed on the right of screen.
M0-M9 ten groups data group
M0 group is the boot default data group. When you extract the data group you need, this data group will cover M0
data group and be automatically stored on M0 data group.
Extract Shortcut storage data group M1 or M2.
On the main interface, keep pressing V/↑or A/↓ more than 2s, you can extract Shortcut storage data group M1 or
M2 quickly. In the same time the corresponding data group number will displayed on the right of the screen.
Extract the specified data group.
On the main interface, keep pressing SET key more than 2s, the sequence number of data group will be displayed on
the right of the screen, you can turn coding potentiometer to choose data group you need. And then press shortly SET
key, you can extract the specified data group you need.
To Next Page
Loading...
Need help?
General
