Ruijie Reyee RG-RAP6260 - System Debugging; 4.1 Debugging Environment Setup; 4.2 Powering up the AP

·
4 System Debugging
4.1 Setting up a Debugging Environment
Power on the AP through PoE.
Setting up the Environment
 Verify that the AP is properly connected to the power source.
 When the AP is connected to a PC for debugging, verify that the PC and PoE switch are properly grounded.
4.2 Powering up the AP
Checking before power-up
 Verify that the power supply is properly connected.
 Verify that the input voltage matches the specification of the AP.
Checking after power-up (recommended)
After powering up, it is recommended that you check the following to ensure normal operation of the AP.
 Check if the LED works normally.