Restore the factory settings.
Power Source
The RG-RAP6260(G) is powered through Power over Ethernet (PoE).
To use a PoE device, make sure it supports the IEEE 802.3at standard.
Reset
The RG-RAP6260(G) supports Cloud management. To reset the device, you can bring the device online and reset it on
Ruijie Cloud.
If the device can not access the Internet, power on the device, press the reset button with a thin rod (as shown in the
figure) for more than 5 seconds, and the device will restore the factory settings.
Figure 1-2 Reset the Device
Before pressing the reset button, please remove the waterproof joint first. Refer to the Chapter 3.5 Connecting
Cables for more information.
Cooling Solution
The AP adopts fanless design.
Leave sufficient space at the surrounding of the AP when place the AP to permit airflow for proper ventilation.
To Next Page
Loading...
Need help?
General
