Ruijie RG-NBS Series - Page 30

1-26
Configuration Guide
eWeb Configuration (Standalone Mode)
1. Select Routed Port from the Port Type dropdown list.
2. Select a protocol. If you select Static IP Address, you can set the IP address and the subnet mask manually (optional).
If you select DHCP, the routed port will obtain a DHCP-assigned IP address.
3. Select a physical port from the panel.
4. Click Save. The message "Operation succeeded." is displayed.
3.4.1.3 Add a L3 Aggregate Port
Figure 3-4-4 Adding a L3 Aggregate Port