1-25
eWeb Configuration (Standalone Mode)
1. Select SVI from the Port Type dropdown list.
2. Select a protocol. If you select Static IP Address, you can set the IP address and the subnet mask manually (optional).
If you select DHCP, the SVI will obtain a DHCP-assigned IP address.
3. If you want to configure an SVI for a VLAN, please make sure that the VLAN is already created.
4. Click Save. The message "Operation succeeded." is displayed.
3.4.1.2 Add a Routed Port
Figure 3-4-3 Adding a Routed Port
To Next Page
Loading...
