Release Notes Upgrade Instructions (12.x)
10
Restart the device after the upgrade is complete to validate the BIN file.
Ruijie#reload
Reload system?(Y/N)y
Ruijie#*May 14 12:51:02: %DP-3-RESET_DEV: Reset device 1 due to
SYSMON/4215/CONSOLE/reset system by reload command.
*May 14 12:51:02: %DP-3-MACHINE_RESTART: MACHINE_RESTART.
[504172.116141] %SYS-0-REBOOT: Rebooting by job: dp_mom_thread/4265
[504172.126545] reboot: Restartin
U-Boot 1.4.14-gc4283be (Mar 21 2020 - 21:56:04 +0800)
Clock Configuration:
CPU0(A53):1200 MHz CPU1(A53):1200 MHz
Bus: 500 MHz DDR: 1600 Mbps
DRAM: 1 GiB (DDR4, 16-bit, CS=2, ECC on)
Flash: SF: Detected mx25l25635f with page size 256 Bytes, erase size 64 KiB,
total 32 MiB
SF: Detected mx25l25635f with page size 256 Bytes, erase size 64 KiB, total 32
MiB
32 MiBMMC: Only Support 3.3 voltage
sdhci@30400000: 0
Loading Environment from SPI Flash... OK
Boot: Master
Net: eth0: ethernet@33410000
Press Ctrl+B to enter Boot Menu, Press Ctrl+C to enter Rboot 0
14 bytes read in 2 ms (6.8 KiB/s)
33 bytes read in 2 ms (15.6 KiB/s)
6814976 bytes read in 150 ms (43.3 MiB/s)
8422045 bytes read in 184 ms (43.7 MiB/s)
36561 bytes read in 3 ms (11.6 MiB/s)
starting pid 1179, tty '': '-/etc/sysinit'
starting initrd
Switching rootfs
[ 4.258085] TIPC: Activated (version 2.0.0)
[ 4.258546] TIPC: Started in single node mode
log: connected to ubus
Press RETURN to get started
Run the “show version” command to confirm the upgrade success:
Ruijie#show version detail
System description : Ruijie Full 25G Routing Switch(S6150-48VS8CQ-X) By
Ruijie Networks
System start time : 2022-07-25 01:41:09
System uptime : 0:00:12:27
System hardware version : 1.00
System software version : S6150-X_RGOS 12.6(2)B1302, Release(09192208)
System patch number : NA
To Next Page
Loading...
