Ruijie RG-S6150-X Series - Page 16

Release Notes Upgrade Instructions (12.x)
12
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!10%
< you can press Ctrl+C to unlock terminal >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!20%
< you can press Ctrl+C to unlock terminal >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!30%
< you can press Ctrl+C to unlock terminal >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!40%
< you can press Ctrl+C to unlock terminal >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!50%
< you can press Ctrl+C to unlock terminal >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!60%
< you can press Ctrl+C to unlock terminal >
100%
Upgrade success

when you see the prompt “Upgrade finish”, the copy operation
is complete (The BIN file takes effect only after the device is restarted).
< The terminal is unlocked by upgrade module >
[Slot 0]
Device type : s57x
Status : success
Ruijie#
Ruijie#reload
Reload system?(Y/N)y
During the upgrade, you can run the “show upgrade status” command to check the
upgrade status
.
Ruijie#show upgrade status
upgrade global status: UPGRADING
[Slot 0]
Device type : s6150-x
Status : upgrading

when the upgrade is complete, it will prompt
“success” here
Restart the device to validate the BIN file.
Ruijie#reload
Reload system?(Y/N)y
Ruijie#*May 14 12:51:02: %DP-3-RESET_DEV: Reset device 1 due to
SYSMON/4215/CONSOLE/reset system by reload command.
*May 14 12:51:02: %DP-3-MACHINE_RESTART: MACHINE_RESTART.
[504172.116141] %SYS-0-REBOOT: Rebooting by job: dp_mom_thread/4265
[504172.126545] reboot: Restartin
U-Boot 1.4.14-gc4283be (Mar 21 2020 - 21:56:04 +0800)
Clock Configuration:
CPU0(A53):1200 MHz CPU1(A53):1200 MHz
Bus: 500 MHz DDR: 1600 Mbps
DRAM: 1 GiB (DDR4, 16-bit, CS=2, ECC on)