24
About Your Rumble Tu Serene Express
1. In Clock/Standby Mode, press the M Button once to go into the Alarm
Adjusting Mode.
2. LCD screen will alternately display two sets of time: Alarm Interval time
(which is the time between each pumping session) and Next Alarm Time.
E.g. If the Power O time of your last session is 10:58 AM and you want to
do the next expression session after 2 hours and 30 minutes, then set the
Alarm Interval Time as 2 hours and 30 minutes. The Next Alarm Time will be
at 1: 28 PM.
3. Roll the Vacuum Adjustment Wheel up (+) or down (-) to adjust the
Alarm Interval Time. The adjustment increases (+) or decreases (-) in 15
minute increments. The Next Alarm Time will be adjusted automatically
according to the last time the pump was used.
Note: The Alarm Interval Time is the time from the end of the last session to the next
alarm set o time. It is NOT the time from the beginning of one expression session
to the beginning of the next one.
4. Press the Expression Button to switch to the Alarm On/O setting.
5. Roll the Vacuum Adjustment Wheel up (+) or down (-) to turn the
Alarm Function On/O.
6. Press the Expression Button again to save your setting.
Note: While in the Alarm Adjusting Mode, if no adjustments are made within 10 seconds,
the setting will automatically save and the LCD Screen will return to Clock/Standby
Mode.
It is advised to pump regularly in order to maintain a good milk supply from
your body. The Alarm Clock Mode is designed to remind you when it is time
for your next pumping cycle. By keeping a regular expression pattern, your
body maintains a good milk supply. After setting the time interval between
each pumping session, the alarm countdown will automatically start after the
previous pumping cycle has stopped. An alarm will sound when the pre-set
time has passed.
To Next Page
Loading...
