MODEL: 63518-N77A1 /63618-N77A3/ 53518-N77B1
36
1. In signal output mode display status, it shows
b-01. Press and enter into program set
mode. and 01flash；
2. Press or to adjust the b-02；
3. Press and hear a sound “Di”, then finish
adjustment, press to turn back.
For example，the fast rinse time of a softener is 12 minutes. After
regenerating, the chloridion in the outlet water is always higher than
normal, indicating that there is not enough time for fast rinse. If you want
the time to set to 15 minutes, the modification steps as follows:
① Press and hold both and to lift the button lock status（
light off）；
② Press ，and light on；
③ Press or continuously until light on. Then the digital
area shows: 4-12M；
④ Press , and12 flash；
⑤ Press continuously until 12 changed to 15；
⑥Press , there is a sound “Di” and the figure stop flashing; the
program back to enquiry status
⑦ If you want to adjust other parameters, you can repeat the steps
from ② to ⑤; If you don’t, press and quit from the enquiry status,
the display will show the current service status.
To Next Page
Loading...
Need help?
General
