Runxin 63604 User Manual

MODEL 63504-F63C1/63604-F63C3/73504-F68C1/73604-F68C3
45
4.Softener fails
to draw brine.
A. Line pressure is too low.
B. Brine line is plugged.
C. Brine line is leaking.
D. Injector is plugged.
E. Internal control leak.
F. Drain line is plugged.
G. Sizes of injector and
DLFC not match with tank.
A. Increase line pressure.
B. Clean brine line.
C. Replace brine line.
D. Clean or replace new parts.
E. Replace valve body.
F. Clean drain line flow control.
G. Select correct injector size and
DLFC according to the P20
requirements.
5.Unit used too
much salt.
A. Improper salt setting.
B. Excessive water in
brine tank.
A. Check salt usage and salt
setting.
B. See problem no.6.
6.Excessive
water in brine
tank.
A. Overlong refilling time.
B. Foreign material in brine
line.
C. Foreign material in
brine valve and plug drain
line flow control.
D. Not install safety brine
valve but power failure
whiling salting.
E. Safety brine valve
breakdown.
A. Reset correct refilling time.
B. Clean brine line.
C. Clean brine valve and brine
line.
D. Stop water supplying and
restart pr install safety brine valve
in salt tank.
E. Repair or replace safety brine
valve.
7.Pressure lost
or iron in
conditioned
water.
A. Iron in the water supply
pipe.
B. Iron mass in the
softener.
C. Fouled resin bed.
D. Too much iron in the
raw water.
A. Clean the water supply pipe.
B. Clean valve and add resin
cleaning chemical, increase
frequency of regeneration.
C. Check backwash, brine draw
and brine tank refill. Increase
frequency of regeneration and
backwash time.
D. Iron removal equipment is
required to install before
softening.

Runxin 63604 Specifications

General

Brand	Runxin
Model	63604
Category	Control Unit
Language	English