Runxin N77A3 User Manual

MODEL: 63518-N77A1 /63618-N77A3/ 53518-N77B1
13
 Press , light on, enter program display mode and use or
to view all values.
 In program display mode, press , flash, enter program set mode,
press or and adjust values.
 Press after all program are set, and then the voice “Di” means all
setting are success and return program display mode.
E. Manual/Return button
 Press in any status, it can proceed to next step.(Example: Press
in Service status, it will start regeneration cycles instantly; Press
while it is in Backwash status, it will end backwash and go to
Brine &Slow Rinse at once.)
 Press in program display mode, and it will return in Service; Press
in program set mode, and it will return program display mode.
 Press while adjusting the value, then it will return program display
mode directly without saving value.
F. Down ▼ and Up ▲
 In program display mode, press ▲or ▼ to view all values.
 In program set mode, press ▲ or ▼ to adjust values
 Press and hold both ▲and ▼for 5 seconds to lift the Button Lock
status.

Runxin N77A3 Specifications

General

Brand	Runxin
Model	N77A3
Category	Control Unit
Language	English