Rupes BR63AE - Technical Specifications; General Guidelines; Starting-Up and Safety

2
SPECIFICATIONS
TYPE
BR63AE
BR65AE
ELECTRIC SHOCK PROTECTION CLASS II II
SUPPLY VOLTAGE ~ 230V-50Hz ~ 230V-50Hz
CURRENT INPUT 2.4A 2.4A
POWER INPUT 550W 550W
ELECTRONIC OVERLOAD PROTECTION YES YES
ELECTRONIC SPEED CONTROL YES YES
WEIGHT 1.9 kg 1.9 kg
VIBRATION FREQUENCY [1/min.] 3000 - 7000 3000 - 7000
ECCENTRIC PITCH 3 mm 5 mm
WORKING DISK DIAMETER 150 mm 150 mm
DUST EXTRACTION YES YES
EXTRACTED DUST VOLUME CONTROL YES YES
GENERAL GUIDELINES
The machine should be used in conjunction with a proper dust extraction system (which is not included in the
set).
STARTING-UP
Before starting the machineup make sure that:
- it shows no visible damage due to transport or storage;
- the machine is complete; check that there is no mechanical damage and if the amount and type of
components comply with the operating instructions;
- the electrical system, to which the tool is to be connected, may carry the load specified in the Table
and on the unit rating plate (see page 10).
INSTRUCTIONS REGARDING SAFETY AND ACCIDENT PREVENTION
Instructions regarding safety and accident prevention during operation are provided in the “Safety Rules”
leaflet, which makes an integral part of these documents; instructions for use contain additional information
concerning the operation of the tool.