Rupes RX253A - Technical Specifications; Correct Usage

7
TYPE RX153A/RX253A RX156A/RX256A
Ø Orbit [mm] 3 6
Ø Backing Pad [mm] 150 150
Backing Pad Thread 5/16” 5/16”
Holes Backing Pad MULTIHOLE MULTIHOLE
R.P.M. 4.000÷10.000 4.000÷10.000
Electronic speed control • •
Power (W) 250 250
Insulation Class I I
Weight [Kg] according to EPTA procedure 1,2 1,2
TECHNICAL SPECIFICATIONS
Summary of device labels containing safety information
WARNING: To reduce the risk of injury, user must read instruction manual
CE marking for EU market Eurasian conformity mark
Wear ear protection Wear eye protection
Wear gloves Wear a mask
Disposal of decommissioned (WEEE Directive)
Arrow – act in the direction indicated by the arrow direction
The values shown are based on a nominal voltage of 230V/50Hz. In case of voltages and frequencies of different power
values may vary. Refer to the label technical specications to the values of the tool.
WARNING!Readallsafetywarnings,instructions,illustrationsandspecicationsprovidedwiththis
power tool. Failure to follow all instructions listed below may result in electric shock, re and/or serious injury. Save all
warnings and instructions for future reference. The safety and accident prevention instructions are reported in the
“SAFETY INSTRUCTION” booklet which is an integral part of these documents. This operating instructions manual
indicates the additional information required for the specic use of the tool.
CORRECT USAGE
• This tool is designed to be used as a sander. Read all safety warnings, instructions, indications provided on
drawingsandspecicationsprovidedwiththistool.Failure to comply with all instructions provided below may
cause electrical shocks, re and/or serious injuries.
• This tool is not intended to be used for metal brushing, polishing and cutting operations. The use of this tool
for unintended applications may cause hazards and injuries to people.
•The tool must be used with accessories that have been specically designed or recommended by the
manufacturer. The xing of the accessory to the tool does not guarantee a safe operation.
•Theratedspeedoftheaccessoriesmustbeatleastequivalenttothemaximumspeedspeciedonthetool.
Using the accessories at speeds above the rated one, may cause them to break or be thrown into the air.
•Theexternaldiameterandthicknessoftheaccessoriesmustmatchthespecicationsofthetool.Accessories
with incorrect dimensions cannot be adequately protected or controlled.
•Thecongurationofaccessoriesmustmatchthetool. The use of accessories that cannot be perfectly tted on
the tool may result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
• Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads and
verify there are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it is not
damaged or install a new accessory. After inspecting or installing an accessory, test the operation of the
tool at maximum speed and without load for one minute, keeping at a safety distance. If the accessories are
damaged, they will break during this test.
ENGLISH