Rupes SSPF - Machine Assembly; Assembly for SSPF, SO84 A, SO73 Models; Assembly for SSCA Model; Abrasive Material Handling

3
THE INSTRUCTIONS TABLE OF CONTENTS
- The “Instructions for Use” leaflet;
- “Safety Rules”;
- Diagram showing individual elements of the machine.
MACHINE COMPONENTS
1. Rating plate
2. Power switch ON/OFF
3. Grip
4. Auxiliary grip
5. Screw for fastening the auxiliary grip
6. Rubber plate with holes for Velcro, rubber plate with holes, standard rubber plate (depending on the
model)
7. Clamp fastening abrasive paper
8. Perforator for abrasive paper (purchased separately)
9. Filter holder
10. Filter
11. Motor ventilation holes
12. Suction pipe terminal (29mm)
13. Pipe connecting turbine with extraction plate (SSCA)
14. Dust bag (SSCA)
INSTRUCTIONS FOR SAFETY AND ACCIDENT PREVENTION DURING WORK
Besides the rules discussed in the “Safety Instructions” leaflet, perform the following:
- cut off the machine compressed air supply before performing any service operations;
- pull out the power supply plug from the mains socket before performing any service operations;
- grip the machine firmly and keep it over the worked surface before switching on;
- assemble the machine correctly, and place the abrasive materials as required.
MACHINE ASSEMBLY
SSPF - SO84A - SO73:
1. Fix auxiliary grip (4) to the machine using provided screw (5);
2. Insert protective filter (10) in its holder (9), and slide it onto the machine body.
SSCA:
1. Fix auxiliary grip (4) to the machine using provided screw (5);
2. Force in the pipe (13) connecting turbine with extraction plate;
3. Fit the dust bag (14).
ABRASIVE MATERIAL FASTENING
SO73 – STANDARD VERSION: RUBBER PLATE
- Press the handle to open the clamp pressing the abrasive material (7).
- Then, slide in the abrasive material under the handle as far as possible. Release the handle.
- Repeat the same operation on the opposite side of the plate. Keep the abrasive paper stretched.
Before releasing the handle check if the edges of the abrasive material are parallel to the plate
edges.
SSPF - SO84A - SO73 – VERSION: RUBBER PLATE WITH HOLES
- Repeat the same operation.
- Perforate the paper using the tool (8).
SSPF - SO84A – VERSION: RUBBER PLATE WITH HOLES FOR VELCRO FASTENING
- Place Velcro-fastened abrasive paper in proper position. Make sure that holes in the paper coincide
with holes in the extraction plate.
BEFORE TOOL START-UP
Make sure that:
- the power supply line complies with the tool characteristics;
- the power cable and plug are in ideal condition;
- the power switch ON/OFF works correctly with cut off power supply;
- all machine parts are installed properly and don’t show any damage;
- ventilation holes are clear (11);