For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 6pm & Saturday 9am – 1pm
or visit us at www.productcareuk.com
24
Trouble Shooting
Fault Possible cause Removing methods
Your appliance does
not fill with water.
• Water tap has been turned off.
• Water inlet hose may be twisted.
• Water inlet hose clogged.
• Valve inlet filter clogged.
• The machine door is not completely
closed.
• Turn the faucet on.
• Check water inlet hose and
untwist.
• Clean water inlet hose filters.
• Clean the valve inlet filters.
• Close the machine door.
Excess foam has
formed in the
detergent draw.
• Excessive amount of detergent used.
• Wrong detergent used.
• Press the Start/pause button.
To eliminate foam formation,
mix a tablespoon of softener
with 500ml of water and pour
the mixture in the detergent
drawer. After 5 – 10 minutes,
press the Start/pause button
again. For the next washing
operation, use the correct
amount of detergent.
• Use detergents produced only
for automatic washing
machines.
Unsatisfactory
washing results.
• The dirtiness of the laundry does not
match the programme select.
• Insufficient amount of detergent used.
• The washing machine is overloaded
with laundry.
• Select the appropriate
programme for the dirtiness of
the laundry. See page 21
• Adjust the amount of detergent
based on the dirt level of the
laundry.
• Load the washing machine with
the correct amount and weight
and do not exceed maximum
laundry capacity.
To Next Page
Loading...
