3
BEFORE USING FOR THE FIRST TIME
• Fill the water tank with clean water, and then empty the water to ensure the tank is clean
of any manufacturing residues. Rell the tank.
• The iron may give off an odour and small amount of vapour when switched on for the rst
time. This is normal and will stop as the element cures.
• Press the
burst of steam button 3 or 4 times, to prime and ush clean water through the
burst of steam pump.
• Press the
cool spray mist button 3 or 4 times, to prime and ush clean water through
the cool spray mist pump.
• Iron an old piece of dampened cotton fabric or linen, to clean the soleplate.
CAUTION: HOT SURFACES
PARTS
1. Temperature control
2. Steam control
3. Water inlet
4. Cover
5. Spray nozzle
6. Soleplate
7. Smart status light
8. Stand
f
g
i
max
k
e
l
m
To Next Page
Loading...
