5
Important Note:
Between ironing tasks always put the iron back onto the stand. This ensures the most efficient
heating and gives you the best performance from your iron.
1. Set the temperature control to the setting you require.
2. Put the iron onto the stand and plug the stand into the power socket (switch the socket on,
if it’s switchable). The smart status light will light up red and your iron will start to heat up.
3. When the smart status light flashes green your iron is ready to use.
REDUCING TEMPERATURE
This can take time, as the iron has to lose the heat it has built up. It is best to organise your
ironing so that you do not need to reduce the temperature.
STEAM IRONING
When steam ironing, you must set the temperature to
or higher.
Make sure the water tank is full.
• Move the steam control to the setting you want.
• Once the smart status light ashes, you can commence ironing.
• The steam control is variable. Choose a position between the
no steam and high
steam that best suits your steam requirements.
• Wait till the temperature light stops ashing, then start ironing.
NOTE: When steam ironing at the lower end of the steam temperature range, it is preferable to
set the steam control to a low steam setting, in order to reduce the incidence of water droplets.
COOL SPRAY MIST
NOTE: Water spotting affects some fabrics. Test this out on
a hidden part of the fabric first. The cool spray mist works
with dry or steam ironing, as long as there is water in the
tank.
• Check that there is water in the tank.
• Lift the iron off the fabric.
• Aim the cool spray mist nozzle at the fabric.
• Press the
cool spray mist button – you may have to
press it 2 or 3 times to pump water through the system.
BURST OF STEAM
Burst of steam works with both dry and steam ironing, as long as
there is water in the tank, and the temperature control dial is set to
or above.
• Check that there is water in the tank.
• Check that the temperature is set to or max.
• Lift the iron off the fabric.
• Press the
burst of steam button – you may have to press it
2 or 3 times to pump water through the system.
• Leave 4 seconds between bursts, to allow the iron
temperature to recover.
To Next Page
Loading...
