Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indic ator on control panel (if pro vided).
Check the rinse aid level
(On models with water softener system only .)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a program
Turn on the water tap and press the . The mac hine will start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the applia nce
Fill the detergent dispenser
Changing the program
Add forgo tten dishes in the
dishwasher .
Scrape off any large amount of leftover food. Soften remnants of burnt foo d in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door, Press the Program Button until the selected program lights up.
( See the section entitled Operation instruction )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Op en the door caref ul l y.
Hot st eam may esc ape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the applianc e, Open the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. O therwise the detergent
m ay have already be en released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button, the machine will be in standby state, press the program
button mo re than 3 seconds then you can change the program to the desired cycle setting
3. Press the Start/Pause Button, the dishwasher will run after 10 second s
Turn off the water tap,
unload the baskets
Warning: wait a few minutes (about 15 min utes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will a lso dry better.Unload the appliance, starting from the lower b asket.
1 .Press the Start/Pau se Butt on to stop the washing.
2 .Open the door a little .
3 .After the spray arms stop working , you can open the d oor
c ompletely.
4 .Add fo rgotten dishes.
5 .C lose the door
6 .Press the Start/Pause Button, the dishwasher will run
a fter 10 seconds.
To Next Page
Loading...
