Russell Hobbs RHF208

10
74. If it’s very dirty, soak it in warm soapy water for a few minutes, rinse under
a running tap, remove all traces of soap, then let it air dry – do NOTret
until it’s completely dry.
75. When it’s dry, replace it in the rear of the cleaner.
76. Thesoftfoamsideoftheltershouldbetowardsthecleanerandtherm
whitesideoftheltershouldbetowardsthecover.
77. Fit the lugs on the bottom of the cover into the slots in the cleaner and push
the top of the cover into the cleaner until it clicks into place.
carrying
handle
outlet
filter
cover
lock
slots
cable
cable rewind
main suction control
(min max)
lugs
on/off switch
Blockages
If the cleaner starts to get noisy and you start to lose suction there is probably
a blockage.
78. Switch the cleaner off and unplug it.
79. Spreadsomenewspaperoranoldtowelontheoortoavoidmakingamess.
80. Ifyou’reusingoneofthetools,removeandcheckitrst.
81. Pull the hose out and check it – leave it out until you have completed the
next steps.
82. Remove the bin and check both ends of the inlet.
83. If there is a blockage, try and remove it with
your hands. Don’t use anything sharp.
84. Checkallthelters.
85. Then reassemble.
86. If you haven’t cleared the blockage,
following these steps, ring customer service.
hose inlet
other end
of inlet passage