Russell Hobbs RHF208

9
59. Ifthelteriscoveredindust,tapitgently over some newspaper or on the rim
of a rubbish bin to dislodge the dust.
60. If it’s very dirty, soak it in warm soapy water for a few minutes, rinse under
a running tap, remove all traces of soap, then let it air dry – do NOTretuntil
it’s completely dry.
Reassembly
61. Wait until everything is completely dry before reassembly.
62. LowertheHEPAlterintothelid,locatingthespindleintothebottomofthe
agitator. Make sure it is fully seated in the lid – it may be necessary to turn
it a bit to clear the lugs inside the lid.
63. LowerthelterassemblyovertheHEPAlter,thenturnitanti-clockwise
tolockitintothelid(it’sabayonet-typetting).
64. Turnthecombinedlidandlterassemblyupsidedown.
65. Align the mark on the lid with the
marked on the bin.
66. Lowerthelidandlterassemblyintothebin.
67. Grip the bin lid with one hand, grip the bin with the other, and turn the lid of
the bin to move the
| mark on the lid from the on the bin round to the .
68. Replacethebininthecleaner–putthebottominrst,thenpushthetop
home. You’ll hear the locks click into place.
69. Check that it’s secure.
lugs
HEPA
filter
spindle
filter
assembly
mark
Check the outlet lter
70. Theoutletlterislocatedonthebackofthecleaner.
71. Press the lock down, pull the top of the cover away from the cleaner and lift
the cover up and off the cleaner.
72. Easetheoutletlteroutofthecleaner.
73. Ifthelterlooksdirty,tapitoversomenewspaperorgentlyontherimofa
rubbish bin to dislodge the dust.