Russell Hobbs RHMP5000

11
USING THE DOUGH BLADE
IMPORTANT: The dough blade can ONLY be used with the large
workbowl. Only run the multi processor on speed 1 when using the
dough blade.
1. Lock the large workbowl into place on the base.
2. Place the dough blade onto the blade shaft and turn it clockwise to lock it into place (N).
Push the dough blade and the blade shaft down onto centre post in workbowl until fully
tted.
3. Insert all the dry ingredients into the workbowl.
4. Place the lid onto the workbowl. Secure large and small food pushers in the feed chute and
process on speed 1.
5. When the appliance is running, add liquids through the opening in the large food pusher.
When nished, press OFF|PULSE to stop the dough blade. Twist the lid clockwise to
remove.
IMPORTANT: Allow the dough blade to stop revolving completely and unplug before removing
the lid.
6. To unlock the workbowl, turn it clockwise and lift off the base.
7. Carefully remove the dough blade by pulling the blade shaft
straight up and empty the workbowl. To remove the dough blade
from the blade shaft, turn the dough blade counterclockwise and
lift off the shaft (O).
8. Empty the the workbowl.
9. Unplug the appliance when not in use.
HELPFUL TIPS WHEN USING THE DOUGH BLADE
• For best results, do not prepare recipes using more than 3 cups our.
• Begin with 1 cup less than the maximum amount of our and add additional our, as
needed, once mixture is well blended.
• Pour liquid through the opening in the large food pusher in a slow steady stream.
• Knead the dough no longer than one minute.
• Do not leave the appliance unattended when in use.
GENERAL TIPS FOR USING THE MULTI PROCESSOR
• Organise your processing tasks to avoid multiple clean-ups of the workbowl; process dry
before wet.
• The multi processor will be more efcient if lled no more than 1/2 to 2/3 full.
• If shredded, sliced or diced food piles up on one side of the workbowl, stop the multi
processor and redistribute the food using a spatula.
• To take advantage of the speed of the processor, drop foods through the feed chute with
the unit running.