Need help?Do you have a question about the Russound A2100 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Weight | 15 lbs |
| Total Harmonic Distortion (THD) | < 0.1% |
| Input Impedance | 10 k ohms |
| Gain | 32 dB |
| Trigger Input | 12V DC |
| Power Output | 100W per channel |
| Impedance | 4 to 8 ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | > 100 dB |
| Protection | Thermal, short circuit |
Highlights the cool running, low-profile, high efficiency design for space-conscious systems.
Details 100W per channel power, buffered loop output, and 12V trigger input/output.
Explains Always On, Signal-sensing, 12V Trigger turn-on modes and stereo/bridge output modes.
Describes removable speaker connectors and the cord lock feature.
Explains safeguards against thermal overload and short-circuit conditions.
The front panel switch and LED for power on/off and status indication.
Describes the analog stereo line input and buffered line output for signal routing.
Details the gain switch used to adjust the audio output volume level.
Covers the output switch for stereo/bridge and the three turn-on mode options.
Explains the 12VDC trigger for power control and the trigger out feature.
Indicates where to connect loudspeakers with support for up to 12 AWG wire.
Describes the connection for the 3-prong grounded IEC power cord.
Instructions and options for mounting the amplifier on a wall.
Details for installing the amplifier in a 1U rack space, single or dual unit.
Describes connections for standard stereo operation with 8 ohm speakers.
Details connections for bridged mode, achieving 225W per channel.
Lists continuous output power ratings and minimum impedance for stereo and bridged modes.
Details power requirements, physical dimensions, and weight of the amplifier.
Outlines the two-year warranty, coverage, exclusions, and return procedures.
To Next Page
