Need help?Do you have a question about the Russound CAA66K and is the answer not in the manual?
General| Zones | 6 |
|---|---|
| Channels | 6 |
| Audio Sources | 6 |
| IR Outputs | 6 |
| Inputs | 6 |
| Frequency Response | 20Hz - 20kHz |
| Outputs | 6 |
Detailed safety guidelines for operating the appliance.
Additional important warnings and guidelines before operating the unit.
Details the front panel features and controls of the CAA66 controller.
Explains the features and functions of the KP6 keypad.
Details the features and functions of the KPL keypad.
Describes the KPSC source control keypad and its capabilities.
Outlines the buttons and functions of the SRC1 remote control.
Explains how to use the User Options Mode on the KP6 keypad.
Details how to adjust audio properties using the KPL keypad's User Options Mode.
Guidance on unpacking, checking, and listing system components.
Lists the necessary tools for installing the system.
Factors to consider before installing the CAA66 system.
Recommendations for making proper electrical and signal connections.
Details RJ-45 wiring standards and keypad connections using CAT-5.
Guidelines for running and connecting speaker wires.
Step-by-step instructions for safely removing the CAA66 controller's front panel.
Identifies and describes the connectors and ports on the rear of the CAA66 controller.
Explains the update jumper and KPSC port on the KP6/KPL keypads.
Details CAT-5 termination and rear panel connections for keypads.
Instructions for inserting source name labels on keypads.
Steps for physically installing the keypad into an electrical box.
Describes connecting keypads to the CAA66 via RJ45 ports and using splitters.
How to connect audio sources to the CAA66 controller.
How to connect IR emitters for source control.
Connecting RNET source audio to the CAA66 controller.
Linking RNET components to the controller using RJ45.
Connecting IR emitters to the common IR port for universal control.
Instructions for connecting 8-ohm speakers using modular connectors.
Explains the fixed/variable audio outputs for zone audio distribution.
Connecting a 12VDC trigger to mute audio in all zones.
Using the 12VDC output to trigger external components.
Connecting multiple CAA66 controllers using CAT-5 patch cables.
Connecting the CAA66 to PCs or automation systems via RS-232.
Steps to test basic hardware functionality before programming.
Overview of the Programming Center, its LEDs, and modes.
Procedure to set the Controller ID for multi-controller systems.
Procedure to set the number of sources available for keypad toggling.
Procedure to reset the controller to factory settings and erase programming.
A flow chart detailing the controller setup process.
Overview of the Source Setup menu for IR control assignment.
Assigning command types for RNET source components.
Assigning UEI library command types and device codes for sources.
Procedure for learning IR commands for unlisted source components.
Procedure to re-enter an invalid command type.
Procedure to clear the current command type of a selected source.
Visual guide of the source setup procedure.
Menu for choosing source names and performing factory initialization.
Diagnostic checks and firmware version verification for the keypad.
Lists source names and their 5-character display for KPL keypads.
Lists source names and their 5-character display for KPL/KP6 keypads.
Lists UEI library IR codes for TVs.
Lists UEI library IR codes for SAT/DSS, VCRs, and Laser Disc Players.
Lists UEI library IR codes for DVD Players, Tuner/Amp, and Home Control.
Detailed technical specifications for the CAA66 unit.
Outlines the warranty terms and the process for returning units for repair.
To Next Page
