Need help?Do you have a question about the Russound R290DS and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Total Harmonic Distortion | <0.1% |
| Gain | 32 dB |
| Trigger Input | 12V DC |
| Damping Factor | >100 |
| Power Output | 90W per channel into 8 Ohms |
| Frequency Response | 20Hz - 20kHz |
User must read all safety and operating instructions before use.
Adhere to all warnings on the appliance and in operating instructions.
Follow all operating and user instructions.
Avoid using the appliance near water or exposing it to liquids.
Avoid direct sunlight, heating units, damp, and dusty places for proper ventilation.
Ensure proper ventilation by not blocking openings or placing in built-in installations.
Connect only to the described or marked power supply type.
User should not attempt service beyond operating instructions; refer to qualified personnel.
Refer to service personnel if power cord, liquid spill, rain exposure, abnormal operation, or damage occurs.
Safeguards amplifier under thermal overload by stopping output and turning off LED.
Safeguards amplifier under short-circuit conditions; front LED indicates fault.
How to connect two audio sources for priority switching.
Steps to configure the amplifier for stereo operation.
Instructions for configuring the amplifier for higher power mono output.
Diagram showing setup with an autoformer-based volume control system.
Details the 2-year limited warranty against defects in materials and workmanship.
To Next Page
