RUSTA ADVANCED - Fitting Components

63
23
Step 12
Connect Curved Top Rail with Leg Sockets (# 2) to Curved Top Rail with Leg Sockets (# 5) and Curved Top
Rail with Leg Sockets (# 4) to Curved Top Rail with Leg Sockets (# 3)
Top Rail with Leg Sockets (# 2) to Curved Top Rail with Leg Sockets (# 8) and Curved Top Rail with Leg
Sockets (# 4) to Curved Top Rail with Leg Sockets (# 9)
12
13
24
Trampoline Mat Assembly
Step 13– Spring Assembly
Place the Trampoline Mat (# 15) flat on the ground inside the assembled frame with the warning labels facing
up. Begin by attaching Springs (# 17) to the four corners of the mat, hook one end of Spring (# 17) into the
Triangle-Ring on the Mat (# 15). Holding the Spring Loading Tool (# D) underhand, pull the other end of the
spring and lock it into the hole on the frame. Please note the two ends of the spring are different and must be
installed as shown in the diagram below. Then continue to attach springs in the sequence.
FITTING THE TRAMPOLINE MAT / MONTERING AV STUDSDUKEN /
MONTERING AV TRAMPOLINEDUKEN / MONTAGE DES SPRUNGTUCHS /
TRAMPOLIININ MATON ASENNUS