Need help?Do you have a question about the Rx Clear 801405 and is the answer not in the manual?
Prepare the valve and locate the standpipe and parts bag within the filter tank.
Securely attach the drain assembly to the bottom of the filter tank using gaskets and a locking nut.
Mount the pump to the base using bolts and nuts, aligning cradle holes with base holes.
Add filter grade sand to the tank, ensuring it is between 1/2 and 3/4 full.
Lubricate and attach the valve to the standpipe, ensuring a proper seal on the tank lip.
Position and tighten the clamp around the filter lip and valve edge for a secure fit.
Connect hoses to the pump and filter valve ports labeled RETURN, PUMP, and WASTE.
Connect hoses for standard aboveground pools between the pump, filter valve, and pool skimmer/return.
Connect hoses for temporary aboveground pools using AC 22764 fittings for specific pool types.
Prime the filter system before starting the pump to prevent damage and ensure proper operation.
Perform backwashing to clean the sand bed and rinsing to clear lines after backwashing.
Operate the filter in FILTER mode and monitor the pressure gauge to determine when backwashing is needed.
Always turn off the pump before changing the valve selector handle position to prevent damage.
Diagnose and resolve problems causing reduced water flow through the filter system.
Identify causes and solutions for the filter system becoming clogged or dirty quickly.
Address issues preventing the pool water from becoming clear, checking chemical levels and filter operation.
Properly disassemble, drain, and store the filter tank and valve to prevent winter damage.
Rinse and store the pump in a warm, dry place to protect it from freezing temperatures.
General| Brand | Rx Clear |
|---|---|
| Model | 801405 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
