Ryobi 790r - User Manual

Questions and Answers

V
Victoria FletcherJul 26, 2025
Why Ryobi Trimmer engine will not start?
- A
  amccartyJul 26, 2025
  If your Ryobi Trimmer engine won't start, there are several potential causes. First, ensure the ignition switch is turned to the ON position. Check the fuel tank and fill it if it's empty. Make sure to press the primer bulb fully and slowly 5-7 times. If the engine is flooded, follow the starting procedure with the choke lever in the RUN position. Old or improperly mixed fuel can also be a culprit, so drain the tank and add fresh fuel mixture. Lastly, a fouled spark plug may be the issue, in which case you should replace or clean it.
T
Toni DavisJul 31, 2025
Why Ryobi Trimmer engine will not idle?
- S
  shannonwilsonJul 31, 2025
  If the engine of your Ryobi Trimmer will not idle, it might be due to a few reasons. The air filter could be plugged, so try replacing or cleaning it. Another possible cause is old or improperly mixed fuel; in this case, drain the fuel tank and add a fresh fuel mixture. Improper carburetor adjustment might also be the problem; adjust it per instructions.
J
Jacob HaleAug 6, 2025
How to fix Ryobi 790r Trimmer cutting head that will not advance line?
- W
  Willie EvansAug 7, 2025
  If the cutting head of your Ryobi Trimmer will not advance the line, several issues could be the cause. The cutting head might be bound with grass, so stop the engine and clean the cutting attachment. The inner reel could be bound up, so refill it with a new line. If the cutting head is dirty, clean the inner reel and outer spool. If the line is welded, disassemble, remove the welded section, and rewind the line. If the line is twisted when refilled, disassemble and rewind it. Finally, if not enough line is exposed, push the Bump Knob and pull out the line until 4 in. (102 mm.) of line is outside of the cutting attachment.
T
Timothy MccarthyAug 13, 2025
What to do if Ryobi Trimmer engine lacks power or stalls when cutting?
- N
  Nicholas SandersAug 13, 2025
  If your Ryobi Trimmer engine lacks power or stalls when cutting, several factors could be responsible. The cutting head might be bound with grass, so stop the engine and clean the cutting attachment. A dirty air filter can also cause this issue, so clean or replace it. Old or improperly mixed fuel is another potential cause; drain the fuel tank and add a fresh fuel mixture. Finally, improper carburetor adjustment may be the problem, requiring you to take it to an authorized service dealer for adjustment.
A
April MitchellAug 19, 2025
What to do if Ryobi Trimmer engine will not accelerate?
- R
  rebekah72Aug 19, 2025
  If your Ryobi Trimmer engine will not accelerate, the problem could stem from old or improperly mixed fuel; drain the fuel tank and add fresh fuel mixture. Alternatively, the carburetor might need adjustment, which should be done by an authorized service dealer.