2
■ Protect battery contact to avoid a short circuit caused by metallic object that can cause a fire or
explosion!
■ Do not rivet or screw any name-plates or signs onto the device. The protective insulation can thereby
be rendered ineffective. Adhesive labels are recommended.
■ Only charge original recommended batteries.
■ If the power cord is damaged, it must be replaced by an Authorised Service Center in order to avoid a
hazard.
WARNING
Do not recharge primary cells (non-rechargeable).
Damage to property/material
Mains voltage must corresp ains voltage must correspond with the voltage specifications on the
device.
ASSEMBLY
No assembly required on this product.
DESCRIPTION
1. Battery Pack (not included) 2. Charger
3. LEDs 4. Power Socket
SPECIFICATIONS
Battery Pack Voltage Charger Input Battery Capacity
AP4001 4 V 220V
-240V, 50Hz-60Hz AC only 1500 mAh
To Next Page
Loading...
