Ryobi EMS2305SCL User Manual

SAVE THIS MANUAL FOR FUTURE REFERENCE.
Your new mitre saw has been engineered and manufactured to Ryobi's high standard for
dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged,
trouble free performance.
CAUTION: Carefully read through this entire owner's manual before using your
SLIDE COMPOUND MITRE SAW.
THANK YOU FOR BUYING A RYOBI 305mm SLIDE COMPOUND MITRE SAW
OWNER’S OPERATING MANUAL
2000 WATT 305 MM SLIDE COMPOUND
MITRE SAW WITH LASER
MODEL EMS2305SCL
Pay close attention to the Rules for Safe Operation, Warnings, and Cautions.
If you use your saw properly and only for what it is intended, you will enjoy years of safe,
reliable service.
Thank You again for buying Ryobi tools.
THANK YOU FOR BUYING A RYOBI 305mm SLIDE COMPOUND MITRE SAW
SPECIFICATIONS:
Power Input 2000W
No Load Speed 4200 min -1
Blade Diameter 305mm
Blade Arbor 16mm
Weight 23kg
Cutting Capacity
Mitre Bevel Max. Width of Cut Max. Depth of Cut
90° 90° 315mm 110mm
45°L/ 45°R 45° 220mm 75mm
45°L/ 45°R 90° 220mm 110mm
90° 45° 315mm 57mm
N197
EMS2305SCL MANUAL 29/4/05 1:54 PM Page 1

Ryobi EMS2305SCL Specifications

General

Blade Diameter	230 mm
Bore Size	30 mm
No Load Speed	5000 rpm
Bevel Capacity Left	45 °
Mitre Capacity Left	45 °
Mitre Capacity Right	45 °
Weight	12.5 kg

Summary

Rules for Safe Operation

Personal Safety Precautions

Dress properly, wear safety glasses, protect lungs and hearing, stay alert.

Tool & Work Area Safety

Keep area clean, avoid dangerous environments, store tools properly, check damaged parts.

Prohibited Operations

Do not operate under influence, do not use if switch is faulty, ensure supervision.

Other Safety Precautions

Blade and Cutting Area Safety

Keep hands away, avoid nails, don't touch moving parts, never start with blade contact.

Laser Operation Safety

Precautions for laser use, aiming, and surface selection.

Assembly and Blade Installation

Fitting the Blade Guard

Blade Removal Procedure

Blade Installation Procedure

Steps to safely install a new saw blade, including alignment.

Adjustments

Setting Cutting Angles

Adjusting mitre and bevel angles for precise cuts.

Mitre Angle Calibration

Bevel Angle Calibration

Basic Saw Operations and Safety

Injury Prevention During Operation

Avoid jams, slips, thrown pieces, and ensure proper setup.

Cut Planning and Execution

Workpiece Handling and Support

Saw Operation Techniques

Operational Safety Guidelines

Warnings on blade brake, short pieces, hand position, and cutting techniques.

Advanced Saw Operations

Bevel and Compound Cut Techniques

Maintenance and Care

General Maintenance Precautions

Use Ryobi parts, avoid solvents, check cords, wear safety gear.