ASSEMBLY
FITTING THE BLADE GUARD.
WARNING : Failure to unplug your saw could result in accidental starting causing
possible serious personal injury.
• Unplug the saw from the outlet. Ensure the cutting head is up to its full extent.
• Loosen the cover plate stop screw (Fig 1) and take note of where guard
screw (supplied with loose
parts) is to be located.
• Fit the guard around the blade and ensure the cover plate of the guard is
located over the cover plate stop screw.
• Fit the guard screw and tighten before tightening the cover plate stop screw.
• Position the connecting bar to the back of the unit and use
the screw pivot
point to fix the bar to the saw (Fig 2). The saw head may need to be moved
up and down slightly in order to correctly locate the screw.
cover plate screw
guard screw
Fig. 1 Fig. 2
To Next Page
Loading...
