Ryobi OWS1815 - Page 11

GETTING STARTED GETTING STARTED
9
1
2
3
1
2
1
2
1
2
9
4
10
Install either the at fan nozzle or cone spray nozzle and
tighten.
Untighten the tank lid and remove it from the tank.
Insert the harness buckle to the harness latch. Pull both
ends of the harness to tighten.
Turn on the product.To start the ow of liquid at the spray
wand, squeeze the trigger.
2
1
6
2
1
5
Fill the tank with the desired amount of liquid (up to 15L). Place the tank lid back onto the tank and tighten.
The cone spray nozzle adjusts the ow of liquid from a
stream to a cone spray.
The at nozzle provides a fan spray.