To Next PageTo Next PageWhy does my Ryobi P318 Nail Gun stop and the LED flash rapidly?
If your Ryobi Nail Gun stops and the LED flashes rapidly, it could be due to a low or uncharged battery. Try recharging the battery. Another reason could be that the tool is overheating. In this case, allow the tool to cool down before using it again.
Why does my Ryobi P318 Nail Gun jam so frequently?
If your Ryobi Nail Gun jams frequently, several factors could be the cause. First, ensure that you are using the correct size of nails. Second, check the nails for any damage and replace them if necessary. Also, make sure the magazine is not loose by tightening the screws. Finally, a dirty magazine can cause jams, so clean it thoroughly.
What to do if Ryobi P318 Nail Gun LED is flashing slowly?
If your Ryobi Nail Gun has a charged battery and the LED is slowly flashing, or the LED doesn't turn off after about ten seconds of non-use, it suggests the tool has malfunctioned. Take the tool to the nearest authorized repair center.
General| Type | Brad Nailer |
|---|---|
| Battery Voltage | 18V |
| Power Source | Battery |
| Depth Adjustment | Yes |
| Adjustable Depth of Drive | Yes |
| Dry-Fire Lockout | Yes |
| LED Work Light | Yes |
| Belt Clip | Yes |
| Tool-Free Jam Release | Yes |
| Battery Included | No |
| Charger Included | No |
| Nail Size | 18-gauge |
| Nail Length | 5/8" to 2" |
| Magazine Capacity | 105 nails |
| Firing Modes | Sequential |
Safety guidelines for maintaining a clean and well-lit workspace.
Precautions to prevent electric shock when using power tools.
Essential personal safety practices for tool operation.
Guidelines for proper operation and maintenance of power tools.
Safety and usage instructions for battery-powered tools.
Procedure for loading pin nails into the tool's magazine.
