10 — English
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
CLEANING THE NAIL CHANNEL
See Figure 12, page 12.
If the tool will not drive a nail, or cycles without driving a nail,
glue residue from the nail strip may need to be cleaned from
the area around the driving mechanism.
Remove the battery pack.
Remove nails from the tool.
Using the hex wrench, remove the two bolts and drive
guide cover.
Use a small amount of air tool oil on a clean cloth or cotton
swab to wipe down the nail channel, removing all traces
of glue.
Reinstall the drive guide cover and bolts, making sure
they are secure.
Reinstall nails in the tool and close the magazine.
NOTE: ILLUSTRATIONS START ON PAGE 11
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Tool operates properly, but fasteners do
not drive fully
Nail is too long for wood hardness Use nail length that is appropriate for
wood
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Tool stops and LED flashes rapidly Battery is low or has no charge
Tool is hot
Recharge battery
Allow tool to cool
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use
Tool has malfunctioned Take tool to nearest authorized repair
center
Tool will not drive a fastener or cycles
without driving a fastener
Driving mechanism is dirty Clean the nail channel as described in
the Maintenance section of the manual
To Next Page
