Ryobi P321 - Troubleshooting

11 — English
NOTE: ILLUSTRATIONS START ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Work-contacting element does not de-
press fully - tool does not operate
Low nails
Work-contacting element is jammed
Replenish nails
Remove battery and clear debris
Tool operates properly, but fasteners do
not drive fully
Air pressure is too low
Depth of drive isn’t deep enough
Nail is too long for wood hardness
Trigger released too soon.
Increase air pressure
Adjust depth of drive
Use nail length that is appropriate for
wood
Hold trigger until fastener is driven.
Tool operates properly, but fasteners are
driven too deep
Air pressure is too high
Depth of drive is too deep
Decrease air pressure
Adjust depth of drive
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Tool stops and LED flashes rapidly Battery is low or has no charge
Tool is hot
Recharge battery
Allow tool to cool
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use
Tool has malfunctioned Take tool to nearest authorized repair
center
Tool will not drive a fastener or cycles
without driving a fastener
Driving mechanism is dirty Clean the nail channel as described in
the Maintenance section of the manual