3
of serious personal injury, do not store outside or in
vehicles.
■ Follow all charging instructions and do not charge the
battery pack or tool outside the temperature range
specified in the instructions. Charging improperly or at
temperatures outside the specified range may damage
the battery and increase the risk of fire.
■ Do not charge battery product in a damp or wet location.
Following the rule will reduce the risk of electric shock.
■ Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage and
stress.
■ An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire and electric shock. If extension cord must
be used, make sure:
a) That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
b) That extension cord is properly wired and in good
electrical condition.
■ Do not operate charger with a damaged cord or plug.
If damaged, have it replaced immediately by a qualified
serviceman.
■ Do not disassemble charger; take it to a qualified
serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
■ Disconnect charger from power supply when not in use.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The operator should pay particular and additional
attention to these points in order to reduce the risk of
serious personal injury.
■ Use the product only for its intended use. Do not alter or
modify the product from the original design or function.
■ Always be aware that misuse and improper handling
of the product can cause injury to yourself and others.
■ Never leave the product unattended while the pump is
in operation.
■ Do not continue to use the product or pump when leaks
are present or if the product does not function properly.
BATTERY AND CHARGER
Model
Compatible battery pack
(not included)
Compatible charger
(not included)
Lithium-Ion
RB18L13
RB18L15
RB18L20
RB18L25
RB18L40
RB18L50
RB18L60A
RB18L90A
BCS618G
BCL14181H
BCL14183H
BCL1418IV*
RC18150U
RC18627U
RC18120
RC18115
* for vehicles with 12V DC outlets
LED FUNCTION
Mode Red LED Action
Power on On Ready to pump.
Pump run dry Flashing
Turn on/off switch to the OFF
position.
Relocate intake lter to deeper
water.
Overload Pulsing
Pump will shut off. Turn on/off
switch to the OFF position.
Inspect the impeller to ensure
there is no obstruction causing
the issue.
MAINTENANCE
■ Cleaning and user maintenance shall not be made by
children without supervision.
■ Refer all servicing to qualified service personnel.
Servicing is required when the product has been
damaged in any way, liquid has been spilled or objects
have fallen into the product, the product has been
exposed to rain or moisture, does not operate normally,
or has been dropped.
■ When servicing, use only original manufacturer’s
replacement parts. Use of any other part could create a
hazard or cause product damage.
■ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and can be damaged by their
use. Use dry cloths to remove dirt, dust, oil, grease, etc.
■ Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
V Volts
Direct current
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
Please read the instructions carefully
before starting the machine.
To Next Page
Loading...
