Ryobi RACPWS3 - Maintenance: Replacing O-rings; O-ring Inspection and Replacement Procedure

REPLACING THE O-RING
1. Remove any damaged or cracked o-ring
from the nozzle wand end or hose end
NOTE: Check nozzle wand end or hose
end for stretched, cracked or split o-ring.
2. Dispose of the damaged o-ring properly.
Contact your local distributor for the
suitable replacement o-ring.
3. Place the o-ring into the intended groove
of the nozzle wand end or hose end.
1
2
3
18
Maintenance