10
WARNING:
Before connecting the buffer/polisher to the power
source, always check to make sure the switch is not in
ON position. Failure to do so could result in accidental
starting of the buffer/polisher resulting in possible serious
personal injury.
ATTACH THE APPLICATION BONNET
See Figure 2.
WARNING:
To avoid injury, always make sure the buffer/polisher is
unplugged before attaching bonnets.
The buffer/polisher comes with two bonnets, one for applying
the polish to the surface and another for buffing the surface.
Both are fitted with a drawstring. The application bonnet is
the one made of 100% terry cloth.
To attach the application bonnet to the pad:
Loosen the drawstring so that the bonnet fits completely
over the pad.
Place the bonnet over the pad so that the outer edge can
be drawn over the top of the pad.
Carefully tighten the drawstring around the pad and
secure it with a bow knot.
Tuck the drawstring inside the bonnet.
WARNING:
The drawstring must be tucked securely inside the bonnet
before turning the buffer/polisher on. Failure to do so
could result in the drawstring being caught between the
motor housing and orbiting foam pad, increasing the risk
of serious personal injury.
APPLY POLISH TO THE APPLICATION
BONNET
Most polishes are either in paste or liquid form. Before using
any polish read all directions on appropriate applications
and proper use.
APPLICATION OF PASTE POLISH
See Figure 3.
Use a putty knife or other flat, blunt object to apply
approximately one rounded teaspoon of paste onto the
bonnet. Evenly spread the paste over the entire surface of
the bonnet.
NOTE: Be careful not to use too much polish at one time. If
the pad becomes saturated, it will not last as long.
Do not apply paste directly to the surface being polished.
OPERATION
Fig. 3
Fig. 2
PASTE POLISH
APPLICATION BONNET
To Next Page
Loading...
