13
TROUBLESHOOTING
Problem Possible Cause Solution
Wax does not go on evenly
Too much wax on the bonnet
Remove a portion of the wax and
retry.
Polishing seems difficult
Bonnet may be worn
Replace bonnet.
Polisher does not turn on
Bad connection to receptacle
Check to make sure plug is properly
seated in outlet. If using an extension
cord, check connection and wire
gauge.
Problem with motor
Call your authorized service center.
Bonnet surface is creased or wrinkled,
resulting in uneven application/buffing
Drawstring is loose
Untie drawstring and retighten.
Pad spins slower than normal or not
at all
Motor needs to be serviced or
replaced
Call your authorized service center.
To Next Page
Loading...
