EasyManua.ls Logo

Ryobi RBC30SBS - Blade Protector and Component Cleaning; Spark Arrestor and Spark Plug Care; Storage Procedures

Ryobi RBC30SBS
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
English
MAINTENANCE
n Remove old string by pulling it from the holes located
on the top of the string head.
BLADE PROTECTOR (Fig. 10)
Always place the blade protector on the blade when the
unit is not in use. The blade protector has clips round the
edges to snap over the blade and keep it in place. Wear
gloves and be cautious when handling the blade.
NOTE: Always remove the blade protector before using
the unit. If not removed, the blade protector could become
a thrown object as the blade begins to turn.
CLEANING THE EXHAUST PORT AND MUFFLER
Depending on the type of fuel used, the type and amount
of lubricant used, and/or your operating conditions, the
exhaust port and muffler may become blocked with
carbon deposits. If you notice a power loss with your
petrol powered tool, a qualified service technician will
need to remove these deposits to restore performance.
SPARK ARRESTOR
The spark arrestor must be cleaned or replaced every
25 hours or yearly to ensure proper performance of
your product. Spark arrestors may be in different locations
depending on the model purchased. Please contact
your nearest service dealer for the location of the spark
arrestor for your model.
ATTACHING THE STORAGE HANGER (Fig. 11)
CLEANING THE AIR FILTER SCREEN (Fig. 12)
n Remove the choke dial as shown.
n Using a soft brush clean the screen as shown, once
clean reverse the removal procedure.
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately.
SPARKING PLUG (Fig. 13)
This engine uses a Champion RCJ-6Y or equivalent
spark plug with 0.63 mm electrode gap. Use an exact
replacement and replace annually.
STORAGE (1 MONTH OR LONGER)
n Drain all fuel from tank into a container approved
for fuel. Run engine until it stops.
n Clean all foreign material from the trimmer. Store it in
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
n Abide by all ISO and local regulations for the safe
storage and handling of fuel. Excess fuel should be
used up in other 2-stroke engine powered equipment.

Other manuals for Ryobi RBC30SBS

Related product manuals