EasyManua.ls Logo

Ryobi RBL26G - GETTING STARTED - PART 1; Preparation and Initial Steps

Ryobi RBL26G
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
GETTING STARTED
(50 : 1)
VI
4x
1
8
2
9
Wear full eye and ear protection, substantial footwear, and
long trousers at all times while operating the product. Do
not operate the product when barefoot or wearing open
sandals.
Pre-mix 2-stroke engine lubricant and unleaded petrol in a
clean container approved for petrol at a 50:1 ratio.
Pull the starter grip sharply until the engine attempts to
start. Do not pull the starter grip more than 4 times.
Set the choke lever to “HALF“ choke position.