9
OPERATION
TO START A WARM ENGINE (FIG. 6):
n Move ignition switch (3) to “ I ” run position.
n Make sure cruise control (4) is locked in idle position.
Do not engage the throttle trigger (2) or cruise control
during the start-up process.
n Rotate the choke dial counterclockwise to the RUN
position.
n Slowly press the primer bulb 7 times.
n Pull the starter grip sharply until the engine runs.
TO STOP THE ENGINE:
n Move ignition switch (3) to “ O ” stop position.
Fig. 6
To Next Page
Loading...
