Ryobi RCS3835T User Manual

10 | English
Read and understand all instructions
before operating the product, follow all
warnings and safety instructions.
Wear eye, ear and head protection.
Wear non-slip safety footwear when
using the product.
Wear non-slip, heavy duty gloves.
Beware of chain saw kickback and
avoid contact with bar tip.
Hold and operate the product properly
with both hands.
Do not operate the product using only
one hand.
Conforms to all regulatory standards
in the country in the EU where the
product is purchased.
Use unleaded petrol intended for
motor vehicle use with an octane
rating of 91 ([R+M]/2) or higher.
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also
each time before refueling.
Add bar and chain oil every time you
add fuel to the product.
Set the chain brake to the RUN
position.
Set the chain brake to the BRAKE
position.
Turn ignition switch to the ON position.
Fully press and release the primer
bulb at least 10 times.
Set the choke lever to the full choke
position.
3XOOWKHVWDUWHUURSHXQWLOWKH¿UVW¿ULQJ
of the engine is heard (no more than
¿YHSXOOV
Set the choke lever to the half
position.
Pull starter grip until the engine starts.
Depress the trigger release and
throttle trigger.
EurAsian Conformity Mark
The guaranteed sound power level is
112 dB
Bar and chain lubricant
Unleaded petrol and 2 stroke oil.
Run position
Half choke position
Full choke position
Lock
Unlock
Rotate to adjust chain tension
+ = Tighten the chain
- = Loosen the chain
Moving direction of the chain.
(Marked under the sprocket cover)
Normal mode
Anti-freeze mode

Ryobi RCS3835T Specifications

General

Motor type	2-stroke motor
Chain brake	Yes
Chain speed	23.8 m/s
Product color	Black, Green
Chain bar length	350 mm
Oil tank capacity	0.21 L
Fuel tank capacity	0.31 L
Engine displacement	37.2 cm³
Carrying case	No
Engine power	1.8 hp
Power source	Gasoline

Weight and Dimensions

Weight	4600 g