Ryobi RLM36B51SP User Manual

3
■ The product must be started with the user
behind the handlebars in the operator
safety zone. Never start the product if:
● Not all four wheels are on the ground.
● The grass discharge chute is exposed
and is not protected by the grass catcher
and grass discharge chute cover.
● Hands and feet of all persons are not
clear of the cutting enclosure.
■ Never operate the product if the on/off
switch on the handlebar does not properly
start and stop the product.
■ Never attempt to lock the on/off switches in
the on position; this is extremely dangerous.
■ Do not force the product. It will do the job
better and safer at the speed for which it
was designed.
■ Stop the blade when crossing gravel
surfaces.
■ Do not pull the product backwards unless
absolutely necessary. If you must back the
product away from a wall or obstruction,
first look down and behind to avoid tripping
or pulling the product over your feet.
■ Stop the motor and allow the blade to
stop if the product has to be tilted for
transportation when crossing surfaces
other than grass, and when transporting
the product to and from the work area.
■ Never use the product with defective guards
or shields, or without safety devices, such
as deflectors or grass collectors, in place.
■ Do not tilt the product when turning on
the motor or while the motor is running. If
absolutely necessary, you may raise the
front of the lawn mower by no more than
5 cm to enable easier starting. Press down
on the handlebar to achieve this. Always
return the mower to its normal position with
all wheels on the ground before cutting.
Tilting the mower exposes the blade and
increases the probability of objects being
thrown and accidental contact with the
blade.
■ Turn on the motor carefully according to
instructions, and keep hands and feet
away from blades. Do not put hands or feet
near or under rotating parts.
■ Never pick up or carry the product while it
is running.
■ Turn off the product, and remove the
isolator key and the battery pack. Make
sure that all moving parts have come to a
complete stop:
● whenever leaving the product
unattended (including disposal of grass
clippings)
● before clearing blockages or unclogging
discharge chute
● before checking, cleaning, or working on
the product
● before removing the grass catcher or
opening the grass discharge chute cover
● after striking a foreign object; inspect the
product for damage and make repairs
as necessary before restarting and
operating the product
● If the product starts to vibrate abnormally
(check immediately)
– inspect for damage, particularly the
blades
– replace or repair any damaged parts
– check for and tighten any loose parts
■ Avoid holes, ruts, bumps, rocks, property
stakes, or other hidden objects. Uneven
terrain could cause a slip-and-fall accident.
■ Always ensure that the motor control cable
is never trapped, pinched or otherwise
damaged during assembly or when folding
the handle.
ADDITIONAL BATTERY SAFETY
WARNINGS
WARNING
To reduce the risk of re, personal injury,
and product damage due to a short circuit,
never immerse your tool, battery pack or
charger in uid or allow a uid to ow inside
them. Corrosive or conductive uids, such
as seawater, certain industrial chemicals,
and bleach or bleach-containing products,
etc., can cause a short circuit.
PRODUCT FEATURES
OVERLOAD AND OVERHEAT PROTECTION
The product has an overload protection device.
When overloading is detected, the product
will automatically turn off. If the overload
protector is actuated, the on/off switch must

Ryobi RLM36B51SP Specifications

General

Brand	Ryobi
Model	RLM36B51SP
Category	Lawn Mower
Language	English