o) Disengage the blade during transport and
p)
disengage the blade:
- before leaving the machine;
-
- before removing the grass bag;
- before adjusting cutting height if the operation
is not performed from the driving seat.
Make sure the accelerator is at minimum
before switching off the engine.
-
nect the spark plug wire;
-
the engine, disconnect the spark plug wire
damage.
the engine again; use the services of an au-
thorised after-sales centre.
-
-
the cause of the vibrations. As a rule, unusual
vibrations are an indication of a problem.
a) Make sure all the nuts and screws are tight, so
the lawnmower is in good operating condition
and safe to use.
b)
-
fore before cleaning, adjusting or repairing.
Never store the lawnmower in a secluded area
Wait for the engine to cool down, before storing
the lawnmower in a secluded area.
e)
petrol deposit area free of grass, leaves or
f)
worn or torn.
-
cause damages and dangers.
the open.
i)
unguarded, lower the blade deck and remove
-
sons starting the machine.
check, the tightening of the blade and of the
engine supporting bolts.
k) Blade sharpening and balancing adjustment,
The same applies to blade replacement with
a new one.
l) The lawnmower blade is sharp and can cut
the blade.
Your lawnmower has been designed in accordan-
a) prevent engine start unless all machine sa-
fety conditions are in place.
1) start switch in position
2) parking brake engaged
cutting blade disengaged
b) in case of lack of even one safety condition,
stop engine;
1) the operator leaves the driving seat with blade
rotation enabled.
2) the grass bag is lifted without having disenga-
ged blade rotation
blade rotation is engaged without the bag ha-
reverse gear is engaged without having disen-
gaged blade rotation.
-
q)
r)
c)
d)
g)
h)
j)
To Next Page
Loading...
