Ryobi ROM-65P - Machine Start-up and Driving; Power Start and Engine Switch-Off; Driving, Stopping, and Grass Cutting

- 25 -
MOVIN
G
CAUTIO
N
-
s
ing. Never change direction o
f
move-
1
2
Increase the number of engine revs
(
if too
l
ow
).
5
-
6
f
orward movement o
f
the machine
.
7
one p
l
ace to anot
h
er an
d
w
i
t
h
t
h
e
bl
a
d
e
di-
sengaged.
-
STOPPING
Press the brake
/
clutch pedal to stop the ma-
c
hine
.
G
RASS CUTTIN
G
Be
f
ore starting reverse travel
“
R”, li
f
t and
d
isengage the blade
.
C
AUTI
ON
The reverse gear cannot be
engage
d
w
i
t
h
t
h
e cutt
i
ng
bl
a
d
e engage
d
.
1
2
position .
5
6
Power start
1 Operate the parking brake.
-
-
- Release the brake/clutch pedal. This will remain
2 Lift the blade deck as far as it will go.
Disengage the blade.
"N"
5
6
8
Follow the instructions in the attached engine
manufacturer’s manual.
"I" position and
then to "START" position
which will return to "I" position.
ENGINE SWITCH-OFF
After using the machine:
1
termediate pos-
ition. Let the engine run for at least
20 seconds
2 position.
Before leaving the machine, engage the par-
(15)
(11)
(12)
Repeat the operation until the engine starts.
After the cold engine is started and runs for a
while, slowly adjust the throttle lever to a
position between and as needed.
9
The throttle lever must be at position
during grass cutting.
(see START- UP ).
Fig.37)
(see START- UP ).
blade rotation engagement lever(17)
(fig.42).
(fig.37)
(fig.37).
Shift the drive/speed change lever (18) to
neutral (fig.39-3).
(fig.39-4).
(13)
(fig.40).
(fig.39).
Sit on the driving seat (7).
Move the drive speed change lever as required
(fig.39-3).
Sit on the driving seat.
Select the drive speed change lever on 1 , 2
or 3.
4
Lower the blade deck to the required height
by shifting the cutting height adjustment lever
(fig.43).