6 Connect the battery connectors to the machine
connection leads and tighten terminal screws
(33).
7 Secure the battery with the rubber strap (34)
2
1 Take the battery (32) out of the box and rest it on
a sturdy surface. Take off the multiple cap (30)
closing the 6 elements (31) (fig.27).
to keep it in “vertical” position.
DO
NOT hold it at an angle.
-
rate the sealed tangs of the bottle and thus allow
3 Replace the multiple cap and press it well down
-
-
-
-
4 Loosen the front cover fixing screw (36) of the
engine compartment and move it away (fig.28).
5 Fit the battery (32) in its housing (fig.29).
and the correct alignment of the blade with the
shown on the technical data table.
servicing the engine itself.
HAZARD Filling up must be done with the
engine switched off in an open and well-
ventilated environment.
DO NOT USE OPEN FLAMES NEAR
THE MOUTH OF THE TANK TO CHECK
THE LEVEL AND DO NOT SMOKE
WHEN FILLING UP.
2
being careful
(fig.27).
(fig.29).
(fig.28).
1 Lift the driving seat (7) and the engine
compartment door (10) (fig.31).
(fig.32).
To Next Page
Loading...
